Shower room waterproof strip installation method introduction:
1. When laying floor tiles, generally speaking, a groove will be left. At this time, cement mortar can be used to smooth it. At this time, a marble shower room waterproof strip is placed, and the shape of the shower room waterproof strip is built with bricks. , and then lay floor tiles or marble chips. When laying the floor tiles, the shower room waterproof strip is embedded in the floor tiles. Then its skirt is only a few millimeters higher on the outer edge of the waterproof strip of the shower room. This kind of waterproof strip of the shower room is actually used as a stone foundation under the shower room with glass, and the glass is placed in the middle of the waterproof strip of the shower room. Yes, the skirt is also to prevent water from seeping under the glass into the shower enclosure waterproofing.
2. If the waterproof strip of the shower room is used for the shower curtain, then measure the installation height during installation, so that the shower curtain can sag naturally and sag into the waterproof strip of the shower room by about three centimeters. Only when this is achieved is the best installation effect. , and after this installation, the water will not splash at all. For example, the biggest disadvantage of the skirt is that if there is no glass on the waterproof strip of the shower room, because the inside and outside of the waterproof strip of the shower room are not generally high and uneven, then the glass below may be glued for a long time. Looseness occurs.